Arcadia OCC Interconnect Cable

The all OCC copper design gives it an unique sonic signature that is truly it own and the ideal choice for solid state equipment where the pursuit is authenticity.

The Arcadia like all of our cables goes through our new Ultra Sonic cleaning process where we run the raw copper through a water bath that is super charged to burn away dirt, oil, particals and impurities on the surface of the wire. This Ultra Sonic Bath also has the added unique effect of giving our cables a pre-burn sound that could take hundreds of hours to achieve through normal use. 

 SPECIFICATION

● Conductor: OCC single crystal copper
● Multi-Strand find strand construction  
● Ultra Sonic cleaning process on individual conductors 
● Insulations: HDPE, FEP/Tef dielectric, PTFE dielectric (wrap)- Insulation is pressure extruded completely encompassing each core evenly.
● Tight Pitch construction
● Cryo-Treated
● Shield1: Aluminum mylar with
● Shield 2: Silver coated copper tight pitch braid
● External insulation: RoHs/Reach Certified 105˚C PVC high flex jacket
● Connector Male (RCA): Low-mass RCAs with OCC copper low resistance Pin assembly 
● Sleeve 1: Polyethylene terephthalate(PET) monofilament sleeve with anti-static ­● fibre in purple
● OD: 8.5mm

Deep Cryo™ Treatment
All of the conductors used in our cables undergo Deep Cryo™ treatment before the insulation is extruded over the metals. Our research has proven that the conductor—and only the conductor— benefits from cryo-treatment. Materials such as polyvinyl chloride (PVC™), Teflon™, PE, and Silicon™ can all be adversely affected by cold-temperature annealing. Cryo-treating non-conductors and insulating materials can cause them to break down and become brittle.
The purity, size, and molecular structure of each conductor determine the specific temperature within the -186ºC to - a 196ºC range that we cryo-treat it at. Zavfino’s research into cold temperature physics has proven that the absolute lowest temperature is not necessarily the best for cryo-treatment.
This is a two-stage process. In the first stage we draw the bare conductor through a ceramic die into an ultrasonic cleaning chamber that bombards the conductor with multiple ultrasonic frequencies. This emulsification process removes all debris from the surface of the wire down to the molecular level and leaves absolutely zero residues.

UltraSonic 7 High Voltage / Thermal Break-in
This is a two-stage process. In the first stage we draw the bare conductor through a ceramic die into an ultrasonic cleaning chamber that bombards the conductor with multiple ultrasonic frequencies. This emulsification process removes all debris from the surface of the wire down to the molecular level and leaves absolutely zero residues. After each individual wire is processed, we strand it into bundles and then subject the bundles to further treatment. During the second stage of the ultrasonic burn-in, we increase the voltage to a higher level that’s just below the threshold of the conductor. This adjustment in temperature allows us to get a unique “break-in effect” normally associated with cables that have had 30 to 40 hours of signal and/or current run through them.